|
Time required: about 30 minutes
Difficulty Level: Easy
Material List:
- blank artist trading card (2.5 x 3.5 inches) or (64 x 89 millimeters)
- scrapbook page with international Christmas wishes
- white cardstock
- red fiber paper
- red corrugated cardstock
- 2 white brads
- red metallic heart with a hole in the top and bottom
- thin silver wire
- double sided adhesive
- transparent double sided adhesive
- motif puncher with Christmas trees
- ribbon netting
- 3-D foam tape or pads
- felt reindeer motif
- stick glue
- hole puncher
- tape
Instructions:
1. Tear a piece of the fiber paper and adhere it to the bottom of the artist trading card with stick glue. It does not have to be even.
2. Punch out 3 trees and place a small foam pad on the backside of each one and lay aside.
3. Cut out the Christmas wish out of the scrapbook paper and place a strip of 3-D foam tape on the backside. Lay aside.
4. Cut a piece of white cardstock the size of 5.5 cm x
4.5 cm.
5. Cut a piece of red corrugated cardboard the size of
5 x 4 cm and adhere it centered on the white cardstock rectangle.
6. Punch a hole in the 2 top corners of the prepared rectangle piece and insert a brad in each hole. Close brad off on the backside of the piece. Cut a piece of silver wire and insert it through the heart. Wrap the wire several times around the rectangle and secure the ends on the backside with a piece of tape.
7. Adhere double sided adhesive on the reindeer and then secure the reindeer on the rectangle piece. Place a piece of foam tape on the backside of the rectangle and lay aside for a moment.
8. Cut a piece of netting and adhere it using transparent double sided adhesive to the artist trading card.
9. Now adhere the rectangle, the trees and the Christmas wish to the ATC.
|
